Common Car Wrap Mistake
There are 4 common vinyl car wrap mistake which will cause some bad effect on the car wrap outcome. Most of the mistake is happened during the vinyl car wrap installation time. Hence, we need to avoid these mistakes in order to wrap the car body nicely. The following is the common vinyl car wrap mistakes :
1. Overstretch The Vinyl Car Wrap Sticker During Heat Blow Process
When we are wrapping the car with vinyl car wrap sticker, most of time we need to stretch the film or sticker. However, it is not good to overstretch the vinyl car wrap sticker during the heat blow process. This is because overstretch the vinyl car wrap during the heat blow process will cause an obvious line on the car wrap body.
During the heat blow process, the adhesive and vinyl car wrap film will memories the its new length and shape after being stretched. After being release from stretching, the car wrap film will form a weird border line in between overstretch and non-stretch sections. Hence, try not to overstretch the vinyl car wrap sticker during the installation process.
2. Overstretch The Vinyl Car Wrap Sticker At The Edge
We need to avoid overstretch the vinyl car wrap sticker at the edge of the car body. When we are wrapping the edge of the car body, we will stretch the car wrap sticker to remove wrinkle. However, we should try not to overstretch the vinyl car wrap sticker. This is because the pull back tension will cause the vinyl car wrap sticker at the edge section to peer up easily.
3. Squeegee Pressure – Too High Or Too Low
During vinyl car wrap installation, we need to squeeze the vinyl car wrap sticker on the car body. Sometime, we will press the squeegee with high pressure. As a result, we will left some scratches on the vinyl car wrap sticker.
On the other hand, we should not squeeze and press the vinyl car wrap sticker with low pressure. This is because the sticker will not stay permanently on the car wrap body. Furthermore, some air will be trap under the vinyl car wrap sticker. As a result, the air bubble and wrinkle will form after a period of time.
Hence, we need to squeeze and pressure the vinyl car wrap sticker properly with nice pressure in order to let the sticker stay permanently on the car body.
4. Excessive Vinyl Car Wrap Film
Most of the time, we will cut the car wrap sticker with extra length and width. However, we should not wrap the car body with too much excessive car wrap sticker. This is because we hardly stretch and pull the car wrap sticker with even force when the sticker has too much extra length. When the vinyl car wrap film is not stretch with even force, we will face a lot of wrinkle and air bubble problem. Hence, we need to control the length and width of the vinyl sticker film during the car wrapping process.